I noticed that for the update from 24.0 to 24.1, the Project Details Report PDF no longer exports with the ability to navigate in Bluebeam with bookmarks- this was very handy for the 24.0 version.

physical as well as thermal (Ground and wire to wire) clearance for communication is required by the client to make clearance charts. (These were available in the previous version but not in new.)

Currently in SpidaCalc you can adjust the elevation between two WEP or pole structures. However, setting an anchor on an incline or decline (relative to the base of the pole) has a notable impact on the corresponding guy strength and vertical load...

There are many NESC 2023 classifications that are grouped differently depending on the rule. For example, Table 232-1 combines the following in the first column: Insulated Communication Conductors And Cable Messengers Overhead Shield/Surge-P...

Add a check box property to wires and equipment to identify them as grounded. Allow this property to be used in the creation of Component Groups for clearance analysis.

Add a wire property for voltage. Allow these to be defined in the client file and used in the creation of Component Groups.

Add support for applying a phase label to a wire that applies throughout the connected length of wire. This is mostly for primary phasing. Allow these to be customized in the client file. Examples include: A, B, C Left, Center, Right Road, Center,...

In Design Status, update the default Clearances icon to something other than a green check mark, which makes it appear that it is passing clearance requirements. Instead, do sometihng like the Analysis icon where if there are no results, it shows ...

We would like the, 'Year of the Pole' added as a text to go with 'height', 'class' and 'pole owner' when using "Export to CAD'. The Year is needed along side the pole profile. See attached sample. The 'Year' should be included in the Component Pro...

Update the SPIDAcalc API to support: Reading project, form, lead, location, design, etc. properties Updating project, form, lead, location, design, etc. properties Getting the currently selected project, lead, location, or design Adding leads, loc...