Request to update the clearances configuration to allow for setting the WEP type(s) to which a midspan clearance should apply. This would allow creating reduced clearance tables for services to buildings as described in NESC 2023, Table 232-1, Foo...

When working on large numbers of poles, it's useful to separate them into categories such as Telco-only, Power-only, Joint Use, etc for easier report export. But when moving poles between leads you can only select one at a time and the list doesnt...

There are multiple use cases for Equipment classes. Grounded/Ungrounded Classes This would allow clearance reporting to easily identify different clearance requirements based on the status of the equipment's grounding. Communication/Utility ...

Enable clearance rules that are orientation-agnostic (apply regardless of which attachment is above or below) and optionally allow different minimum clearances depending on the relative position. Current rules require an upper-attachment → lower-a...

There are many NESC 2023 classifications that are grouped differently depending on the rule. For example, Table 232-1 combines the following in the first column: Insulated Communication Conductors And Cable Messengers Overhead Shield/Surge-P...

Add a check box property to wires and equipment to identify them as grounded. Allow this property to be used in the creation of Component Groups for clearance analysis.

Add a wire property for voltage. Allow these to be defined in the client file and used in the creation of Component Groups.

Add support for applying a phase label to a wire that applies throughout the connected length of wire. This is mostly for primary phasing. Allow these to be customized in the client file. Examples include: A, B, C Left, Center, Right Road, Center,...

Currently in SpidaCalc you can adjust the elevation between two WEP or pole structures. However, setting an anchor on an incline or decline (relative to the base of the pole) has a notable impact on the corresponding guy strength and vertical load...

I noticed that for the update from 24.0 to 24.1, the Project Details Report PDF no longer exports with the ability to navigate in Bluebeam with bookmarks- this was very handy for the 24.0 version.