physical as well as thermal (Ground and wire to wire) clearance for communication is required by the client to make clearance charts. (These were available in the previous version but not in new.)

in the previous version we had bookmarks for the pdf report which made it easier to check the analysis result.

Currently in SpidaCalc you can adjust the elevation between two WEP or pole structures. However, setting an anchor on an incline or decline (relative to the base of the pole) has a notable impact on the corresponding guy strength and vertical load...

With framing assemblies, the user can select the type of wires to be used in the assembly prior to placing. Support assemblies allows us to create common guying assemblies (such as 2 guys to 1 anchor, 2 guys to 2 anchors, and 4 guys to 4 anchors f...

It would be great to be able to batch generate separate PDF reports for each location in the SPIDA file. Currently we can generate one single PDF with every pole or we can check the individual poles and generate the report but we that is time inte...

If the ownership of the equipment is changed in spida, make it so analysis does not have to be run. Also, the poles can keep their current results? For example, if I had to change ownership on all poles in a project today from company#1 to company...

Update the SPIDAcalc API to support: Reading project, form, lead, location, design, etc. properties Updating project, form, lead, location, design, etc. properties Getting the currently selected project, lead, location, or design Adding leads, loc...

I noticed that for the update from 24.0 to 24.1, the Project Details Report PDF no longer exports with the ability to navigate in Bluebeam with bookmarks- this was very handy for the 24.0 version.

To being able to have a more precise pole look, some equipment are attached on crossarm.

In Design Status, update the default Clearances icon to something other than a green check mark, which makes it appear that it is passing clearance requirements. Instead, do sometihng like the Analysis icon where if there are no results, it shows ...