Enable clearance rules that are orientation-agnostic (apply regardless of which attachment is above or below) and optionally allow different minimum clearances depending on the relative position. Current rules require an upper-attachment → lower-a...

When working on large numbers of poles, it's useful to separate them into categories such as Telco-only, Power-only, Joint Use, etc for easier report export. But when moving poles between leads you can only select one at a time and the list doesnt...

There are many NESC 2023 classifications that are grouped differently depending on the rule. For example, Table 232-1 combines the following in the first column: Insulated Communication Conductors And Cable Messengers Overhead Shield/Surge-P...

Add a check box property to wires and equipment to identify them as grounded. Allow this property to be used in the creation of Component Groups for clearance analysis.

Add a wire property for voltage. Allow these to be defined in the client file and used in the creation of Component Groups.

Add support for applying a phase label to a wire that applies throughout the connected length of wire. This is mostly for primary phasing. Allow these to be customized in the client file. Examples include: A, B, C Left, Center, Right Road, Center,...

physical as well as thermal (Ground and wire to wire) clearance for communication is required by the client to make clearance charts. (These were available in the previous version but not in new.)

in the previous version we had bookmarks for the pdf report which made it easier to check the analysis result.

Currently in SpidaCalc you can adjust the elevation between two WEP or pole structures. However, setting an anchor on an incline or decline (relative to the base of the pole) has a notable impact on the corresponding guy strength and vertical load...

With framing assemblies, the user can select the type of wires to be used in the assembly prior to placing. Support assemblies allows us to create common guying assemblies (such as 2 guys to 1 anchor, 2 guys to 2 anchors, and 4 guys to 4 anchors f...